LaMotte Bromine /Chlorine Plus Phosphate Waterlink Spin Disk 4329-J, 100 pack

4329-J LaMotte Spin Disk - (100/box) - Series 203

Enhance your testing efficiency with the LaMotte Spin Disk 4329-J Series 203. These easy to use disks will test 10 chemical factors in 60 seconds saving your team time and money. The NSF/ANSI50 Level 1 accuracy ensures your team gets the most accurate pool and spa water testing available on the market meeting or exceeding health department regulations.

Supercharge Your LaMotte Spin Touch

Enhance your LaMotte Spin Touch by integrating it with Pool Shark H2O commercial pool software. The LaMotte Spin Touch seamlessly connects with the Pool Shark H2O app, allowing you to log commercial pool water test results at the press of a button!

Experience the future of water testing with the WaterLink Spin Touch and streamline your pool and spa maintenance like never before.

Lamotte Mobile Waterlink Spin Touch is there for you, and PoolShark H2O app will seamlessly connect with the Spin Touch.

PoolShark H2O app will help you stay compliant with state and county health codes and prolong the life of your pool!

Test Factors

• Free Chlorine (DPD)
• Total Chlorine (DPD)
• Bromine (DPD)
• pH
• Calcium Hardness
• Total Alkalinity
• Cyanuric Acid
• Copper
• Iron
• Salt
• Phosphate

Reliable Results

• Virtually Eliminates User-Error
• Pre-Measured Reagents
• Meter Calibration Check System
• New 6-Wavelength Photometer

Correct Disk Filling - Single-Use Disks

Instructions:

1. Handle with Care: Avoid touching LaMotte Spin Disk's the top and bottom. Fingerprints can interfere with light readings, affecting results. Hold the disk by the edges.
2. Prepare the Syringe: Ensure the syringe is empty by pushing the plunger down completely. You don't want leftover water from previous tests.
3. Fill the Syringe:
   • Insert the syringe tip fully into your water sample.
   • Slowly pull the plunger back to fill the syringe.
   •  To remove air bubbles, gently tap the filled syringe to release them upwards. Push a little water out to expel any remaining bubbles.
4. Position the Disk: Place the disk on a flat, clean, and dry surface. Never attempt to fill it while holding it or inside the testing device.
5. Fill the Disk:
   • Insert the syringe tip vertically into the designated fill hole on the disk. The syringe should stand upright on its own if inserted correctly.
   • Press the plunger slowly and smoothly to fill the disk.
   • Watch the water fill the chambers between the baffles in a counterclockwise direction, from bottom to top.
6. Fill to the Line: Continue adding water until the fourth chamber (the one furthest from the fill hole) fills completely to the top and slightly past the embossed fill line.
   • Overfilling is okay: Excess water will flow out of a designated overflow hole in the center, and the disk won't leak. Simply dry the disk before testing.
   • Underfilling is not okay: If you stop before reaching the fill line, the test results might be inaccurate.

Additional Tips:

• Refer to your specific test kit's instructions for any variations in the filling process.
• Fill and use the disk within 10 minutes for optimal accuracy. Avoid pre-filling the disk.
• Discard the used disk after testing.